Nested cutting lists, offcut policy and kiln losses - how yield engineering keeps dining armchairs prices stable.
Yield starts at the board
The price of a dining armchair frame hides a cutting list. How parts are nested on the board decides how much of the timber becomes product and how much becomes shavings - and yield is engineered, not hoped for.
The arm is the heavy section: 35 to 45 mm where it meets the back post, tapering forward. Back posts run 35 to 40 mm because the arm loads them, and the seat rails 22 to 25 mm. Arms are cut from a blank thicker than anything a side chair uses.
Arms are nearly always ash, because a shaped arm needs a timber that holds a curve and takes a knock; rubberwood marks too readily for a surface people grab. Most of the charge in this category is ash for that reason.
Cutting lists are nested per model
Parts are nested by length and grain direction before the saw runs. The offcut policy is written: what is kept, what is binned, and what goes to smaller parts of other models.
The arm is the expensive machining job in this category. It is a shaped, tapered component that has to meet the back post at a fixed angle, and that tenon is cut on the tenoner rather than by hand — a hand-cut arm joint is the failure we get called about.
| Stage | Control | Result |
|---|---|---|
| Cutting | Nested parts lists | Yield engineered per model |
| Offcuts | Written policy | Kept, reused or binned |
| Cloth | Nested markers | Fabric waste controlled |
| Kiln degrade | Metered | Feeds timber selection |
| Packing | Right-sized cartons | Freight is waste too |
Where waste lives
Cloth gets the same treatment
Upholstery covers are nested markers for the same reason - fabric waste is money too, and the marker is the difference between a competitive quote and a fat one.
Arms are the hardest part to cover cleanly. On upholstered models the cover is cut with the pattern running along the arm rather than around it, because an arm seen from above shows every mistake in the lay of the fabric.
Kiln losses are counted
Drying is not free of losses; degrade is metered and fed back into timber selection so the next batch buys better.
Arm stock at 35 to 45 mm is the thickest material in this category and the slowest to dry. Push it and you get checking inside the arm, invisible under finish, and the arm later fails at the joint rather than in the middle.
Why waste control is the buyer's business
A factory that controls yield quotes stable prices across orders. One that doesn't quotes whatever the offcut bin looks like that week.
Packing runs 0.14 to 0.20 m³ for two with protective arm covers, because an arm is the easiest thing to damage in transit and the most expensive to replace. MOQ is 6 pieces per model.
The catalogue lists 253 models in this category: 87% on a solid or wood frame and 13% with an upholstered or soft cover.
Reference
Questions
Does yield affect my price?
Directly. A nested cutting list is why repeat orders hold their price instead of drifting up.
Can I buy the offcuts?
No - offcuts feed smaller parts and the bin; they are not a product.
Is nested cutting only about cost?
It is also about grain direction - the nesting respects grain, so yield and quality move together.
How does packing relate to waste?
An oversized carton wastes board and freight at the same time; cartons are sized to the dining armchair, not to a standard box.