Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Restaurant Chairs

Seat Deck Construction: Webbing, Springs and Plywood on Restaurant Chairs

The layer under the foam decides the seat in year three - webbing, springs and formed ply compared for restaurant chairs.

Updated 2026-11-15Longjiang, Foshan11 min read

The layer under the foam decides the seat in year three - webbing, springs and formed ply compared for restaurant chairs.

These notes come off the production floor in Longjiang, Foshan. The current wholesale restaurant chairs range is on the main site, with a specification page for every model in it.

Under every seat there is a decision

Elastic webbing, metal springs or a formed plywood deck - the base under the foam decides how a restaurant chair feels in year three, and each system has a different failure signature.

A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.

Webbing: light and forgiving

Elastic webbing is quick to fit and comfortable from day one; it needs the frame rail spacing designed for it, or it sags where the rails span too wide.

Corner blocks glued and screwed, stretchers on the heavier models, and a seat rail section big enough to take a repeated racking load. The test regime cycles the frame far harder than a domestic standard does.

DeckCharacterWatch point
Elastic webbingLight, forgivingRail spacing critical
Metal springsCyclic loadsHeavy service
Formed plyFlat, predictableContract foam platforms
FixingsTorqued, gaugedCrack prevention
Sit testvs retained sampleComfort drift caught

Seat deck options

Springs and formed ply: the contract options

Springs take heavy cyclic loads; a formed plywood deck gives a flat, predictable platform for firm contract foam. Upholstered restaurant chairs for venues usually land on one of these two.

Covers are chosen for cleanability: PU, leather and tight-weave fabric, abrasion 30,000 rubs and up. A restaurant that cannot wipe a seat down in ten seconds will not keep it in service for a year.

How decks fail

Sagging webbing, a cracked ply panel at the fixing points, or foam that bottomed out because the deck was too soft for its load. All three are visible in a retained sample comparison.

Seats delaminating under daily wiping, stretchers loosening on models that get dragged rather than lifted, and finishes going dull where the cleaning agent is too alkaline. Ask what cleaner the operator uses.

What the inspection checks

Deck fixing torque, webbing tension and a sit test against the retained sample - because comfort drift is still drift.

EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.

Questions

Which deck is in your standard restaurant chair?

The specification sheet names it per model; contract versions of the same model may carry a different deck.

Can I upgrade the deck on an order?

Yes - decks are a specification choice, quoted with the model.

Why does my seat sag at the front?

Usually webbing span or foam density; the retained sample tells you which, and the fix is a specification change, not a warranty debate.

Do decks differ by category?

By load and use - a restaurant chair and a restaurant chair rarely share the same deck construction.