Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Lounge Chairs

Seat Deck Construction: Webbing, Springs and Plywood on Lounge Chairs

The layer under the foam decides the seat in year three - webbing, springs and formed ply compared for lounge chairs.

Updated 2026-11-15Longjiang, Foshan11 min read

The layer under the foam decides the seat in year three - webbing, springs and formed ply compared for lounge chairs.

These notes come off the production floor in Longjiang, Foshan. The current wholesale wooden lounge chairs range is on the main site, with a specification page for every model in it.

Under every seat there is a decision

Elastic webbing, metal springs or a formed plywood deck - the base under the foam decides how a lounge chair feels in year three, and each system has a different failure signature.

A lounge chair is a soft seat on a frame, not a frame with a pad. 220 of the 226 models in this category are upholstered, so the frame is a substrate: it has to hold the foam and the cover in shape under a sitter who stays put for an hour, not one who leaves in twenty minutes.

Webbing: light and forgiving

Elastic webbing is quick to fit and comfortable from day one; it needs the frame rail spacing designed for it, or it sags where the rails span too wide.

Frames are wood or metal under the cover, and the load path goes through the seat deck rather than the rails. Webbing or a sprung deck decides how the seat feels after a year more than the timber species does.

DeckCharacterWatch point
Elastic webbingLight, forgivingRail spacing critical
Metal springsCyclic loadsHeavy service
Formed plyFlat, predictableContract foam platforms
FixingsTorqued, gaugedCrack prevention
Sit testvs retained sampleComfort drift caught

Seat deck options

Springs and formed ply: the contract options

Springs take heavy cyclic loads; a formed plywood deck gives a flat, predictable platform for firm contract foam. Upholstered lounge chairs for venues usually land on one of these two.

Foam density is the specification that matters: 30 to 35 kg/m³ for a lobby, lower for a showroom piece. Covers are velvet, fabric or leather, and where the market requires it we can supply to BS 5852 or CAL 117 — specify at quotation, not after.

How decks fail

Sagging webbing, a cracked ply panel at the fixing points, or foam that bottomed out because the deck was too soft for its load. All three are visible in a retained sample comparison.

Seats that bottom out, covers that pill at the front edge, and frames that creak because the deck was stapled rather than webbed. Comfort complaints are almost always foam density, not frame strength.

What the inspection checks

Deck fixing torque, webbing tension and a sit test against the retained sample - because comfort drift is still drift.

Comfort testing counts as much as strength here: foam compression set under repeated loading, cover abrasion, and a frame fatigue test at Level 1 or Level 2 depending on the traffic the lobby actually sees.

Questions

Which deck is in your standard lounge chair?

The specification sheet names it per model; contract versions of the same model may carry a different deck.

Can I upgrade the deck on an order?

Yes - decks are a specification choice, quoted with the model.

Why does my seat sag at the front?

Usually webbing span or foam density; the retained sample tells you which, and the fix is a specification change, not a warranty debate.

Do decks differ by category?

By load and use - a lounge chair and a lounge chair rarely share the same deck construction.