Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Bar Stools

Seat Deck Construction: Webbing, Springs and Plywood on Bar Stools

The layer under the foam decides the seat in year three - webbing, springs and formed ply compared for bar stools.

Updated 2026-11-14Longjiang, Foshan11 min read

The layer under the foam decides the seat in year three - webbing, springs and formed ply compared for bar stools.

These notes come off the production floor in Longjiang, Foshan. The current wooden bar stools supplier range is on the main site, with a specification page for every model in it.

Under every seat there is a decision

Elastic webbing, metal springs or a formed plywood deck - the base under the foam decides how a bar stool feels in year three, and each system has a different failure signature.

A stool carries its load differently from a chair. The seat is high, the base is narrow relative to the height, and the footring takes a sideways kick every time someone climbs on or pushes off. That is why the ring on our stools is a welded closed section joined to the column, not a ring screwed into a leg.

Webbing: light and forgiving

Elastic webbing is quick to fit and comfortable from day one; it needs the frame rail spacing designed for it, or it sags where the rails span too wide.

The critical junction is where the column meets the seat mount and where the footring meets the column. On a swivel model the gas lift is a bought-in component and we test the assembly, not just the frame: a lift rated for office duty is not the same part as one rated for a bar that runs twelve hours a day.

DeckCharacterWatch point
Elastic webbingLight, forgivingRail spacing critical
Metal springsCyclic loadsHeavy service
Formed plyFlat, predictableContract foam platforms
FixingsTorqued, gaugedCrack prevention
Sit testvs retained sampleComfort drift caught

Seat deck options

Springs and formed ply: the contract options

Springs take heavy cyclic loads; a formed plywood deck gives a flat, predictable platform for firm contract foam. Upholstered bar stools for venues usually land on one of these two.

Seats are the part that fails first on a stool. Leather and velvet covers around 26 of the 88 models take a knee-slide load that a dining chair never sees, so the seam is placed away from the front edge and the foam is wrapped rather than loose.

How decks fail

Sagging webbing, a cracked ply panel at the fixing points, or foam that bottomed out because the deck was too soft for its load. All three are visible in a retained sample comparison.

The three returns we see: footring welds cracking after a season, swivel mechanisms that lose their gas, and seat pads compressed flat at the front edge. All three are specifiable — a closed-section ring, a contract-rated lift, and a 35 kg/m³ foam.

What the inspection checks

Deck fixing torque, webbing tension and a sit test against the retained sample - because comfort drift is still drift.

Beyond the frame test a stool gets a stability check at height and a footring load test: push the ring sideways with the stool loaded and it must not deform. Swivel models are cycled, not just sat on.

Questions

Which deck is in your standard bar stool?

The specification sheet names it per model; contract versions of the same model may carry a different deck.

Can I upgrade the deck on an order?

Yes - decks are a specification choice, quoted with the model.

Why does my seat sag at the front?

Usually webbing span or foam density; the retained sample tells you which, and the fix is a specification change, not a warranty debate.

Do decks differ by category?

By load and use - a bar stool and a bar stool rarely share the same deck construction.