Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Restaurant Chairs

Sanding and Finishing Restaurant Chairs: Three Grits to Final Coat

The sanding sequence, the raking-light inspection and the reference panel that decide how a restaurant chair looks under a dining room light.

Updated 2026-11-14Longjiang, Foshan11 min read

The sanding sequence, the raking-light inspection and the reference panel that decide how a restaurant chair looks under a dining room light.

These notes come off the production floor in Longjiang, Foshan. The current restaurant chairs supplier range is on the main site, with a specification page for every model in it.

Three grits, two inspections, one finish

Sanding is where a restaurant chair earns its surface. Three grits in sequence, an inspection under raking light between the second and third, and no finish until the bench signs off.

Finishes are specified for cleaning, not for depth of sheen. A restaurant seat is wiped with an alkaline agent several times a day, so the coating is chosen for chemical resistance, and the seat edges where the cloth catches are the first thing inspected.

Why sanding is compressed when a line is late

It is the easiest stage to rush and the first one the customer sees. A stain over a poorly sanded rail shows every scratch under a dining room light, so the schedule protects this bench, not the other way round.

Contract sections run heavier than domestic: 45 to 55 mm legs, 25 to 30 mm rails, and a stretcher on the models that get dragged rather than lifted. The extra section is not for show — it is what survives a room being re-set several times a day.

StagePurposeCheck
Grit 1Flatten and shapeMachine marks gone
Grit 2Uniform scratchRaking-light inspection
Grit 3Finish preparationBench sign-off
Stain / sealerColour vs reference panelUnder D65 light
Top coatsScuff + tack betweenGloss and feel

Sanding sequence

Species sand differently

Open-grain timber drinks stain and shows swirl marks; tight grain shows gloss differences. Grit sequence and sanding direction are set per species, not per shift.

Ash carries most of this programme and rubberwood covers the rest, both bought to a specification that assumes contract service: ash where the frame takes a daily racking load, rubberwood where the price point has to work.

Between coats, not just before them

Each finish coat gets a scuff and a tack cloth before the next; the final coat is compared against a sealed reference panel, not against the piece next to it.

EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.

The surface you will actually live with

Buyers ask about gloss and colour; the number that matters in service is how the finish stands up to cleaning agents, which is a packing-hall question as much as a spray-booth one.

This stock moves in volume and it is metered at packing as well as at the kiln, because a container of restaurant seating sits in a humid port before it is unloaded, and the reading at destination is the one that matters.

Seats delaminating under daily wiping, stretchers loosening on models that get dragged rather than lifted, and finishes going dull where the cleaning agent is too alkaline. Ask what cleaner the operator uses.

Questions

What sheen levels can I order?

Matt, satin and semi-gloss on restaurant chairs, all matched to a sealed panel rather than a photo.

Can you match a colour I send?

Physical samples, yes; screen colours, no. Colour is signed off on a stained panel before the batch runs.

How do you keep 300 restaurant chairs the same colour?

One stain batch per order, one reference panel, and the booth checks against it - not against the previous chair.

What finishes are available?

NC, PU and water-based systems; the trade-offs are on the finishing page for restaurant chairs.