Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Lounge Chairs

Sanding and Finishing Lounge Chairs: Three Grits to Final Coat

The sanding sequence, the raking-light inspection and the reference panel that decide how a lounge chair looks under a dining room light.

Updated 2026-11-13Longjiang, Foshan11 min read

The sanding sequence, the raking-light inspection and the reference panel that decide how a lounge chair looks under a dining room light.

These notes come off the production floor in Longjiang, Foshan. The current wooden lounge chairs supplier range is on the main site, with a specification page for every model in it.

Three grits, two inspections, one finish

Sanding is where a lounge chair earns its surface. Three grits in sequence, an inspection under raking light between the second and third, and no finish until the bench signs off.

Almost none of the frame shows. What matters is that nothing rough touches the cover from inside: a splinter on a rail wears through fabric from the back within months, which is why upholstered frames are sanded and sealed even where no one will look.

Why sanding is compressed when a line is late

It is the easiest stage to rush and the first one the customer sees. A stain over a poorly sanded rail shows every scratch under a dining room light, so the schedule protects this bench, not the other way round.

The frame is a substrate for upholstery, so sections run lighter than a dining chair: 30 to 40 mm on the load-bearing rails, with a shaped ply or a webbed deck carrying the seat. Timber here is dried for stability rather than for appearance — most of it is never seen.

StagePurposeCheck
Grit 1Flatten and shapeMachine marks gone
Grit 2Uniform scratchRaking-light inspection
Grit 3Finish preparationBench sign-off
Stain / sealerColour vs reference panelUnder D65 light
Top coatsScuff + tack betweenGloss and feel

Sanding sequence

Species sand differently

Open-grain timber drinks stain and shows swirl marks; tight grain shows gloss differences. Grit sequence and sanding direction are set per species, not per shift.

The timber here is mostly hidden, so the programme runs ash and rubberwood on cost and stability rather than on figure. In this category the species conversation is about the cover, not the frame.

Between coats, not just before them

Each finish coat gets a scuff and a tack cloth before the next; the final coat is compared against a sealed reference panel, not against the piece next to it.

Comfort testing counts as much as strength here: foam compression set under repeated loading, cover abrasion, and a frame fatigue test at Level 1 or Level 2 depending on the traffic the lobby actually sees.

The surface you will actually live with

Buyers ask about gloss and colour; the number that matters in service is how the finish stands up to cleaning agents, which is a packing-hall question as much as a spray-booth one.

Frames for upholstery go straight from the conditioned store to machining, because a frame that has picked up moisture will move after the cover is fitted — and a cover hides that movement until the seam splits.

Seats that bottom out, covers that pill at the front edge, and frames that creak because the deck was stapled rather than webbed. Comfort complaints are almost always foam density, not frame strength.

Questions

What sheen levels can I order?

Matt, satin and semi-gloss on wooden lounge chairs, all matched to a sealed panel rather than a photo.

Can you match a colour I send?

Physical samples, yes; screen colours, no. Colour is signed off on a stained panel before the batch runs.

How do you keep 300 lounge chairs the same colour?

One stain batch per order, one reference panel, and the booth checks against it - not against the previous chair.

What finishes are available?

NC, PU and water-based systems; the trade-offs are on the finishing page for wooden lounge chairs.