Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Solid Wood Dining Chairs

Sanding and Finishing Dining Chairs: Three Grits to Final Coat

The sanding sequence, the raking-light inspection and the reference panel that decide how a dining chair looks under a dining room light.

Updated 2026-11-13Longjiang, Foshan11 min read

The sanding sequence, the raking-light inspection and the reference panel that decide how a dining chair looks under a dining room light.

These notes come off the production floor in Longjiang, Foshan. The current solid wood dining chairs range is on the main site, with a specification page for every model in it.

Three grits, two inspections, one finish

Sanding is where a dining chair earns its surface. Three grits in sequence, an inspection under raking light between the second and third, and no finish until the bench signs off.

The seat is the surface people touch and see. A solid wood seat is sanded to a finer grit than the frame and the end grain is sealed, because a seat splits from the end outwards. Frames get the standard three-grit sequence.

Why sanding is compressed when a line is late

It is the easiest stage to rush and the first one the customer sees. A stain over a poorly sanded rail shows every scratch under a dining room light, so the schedule protects this bench, not the other way round.

Legs are cut from 42 to 50 mm square, seat rails from 20 to 25 mm, back posts 30 to 35 mm where the model carries a shaped back. The thin end — a 20 mm rail — is where drying matters most, because a thin section releases moisture fast and moves first.

StagePurposeCheck
Grit 1Flatten and shapeMachine marks gone
Grit 2Uniform scratchRaking-light inspection
Grit 3Finish preparationBench sign-off
Stain / sealerColour vs reference panelUnder D65 light
Top coatsScuff + tack betweenGloss and feel

Sanding sequence

Species sand differently

Open-grain timber drinks stain and shows swirl marks; tight grain shows gloss differences. Grit sequence and sanding direction are set per species, not per shift.

Around 70% of what we run is ash and roughly 30% rubberwood, and both appear in this category's charge book. Ash dries steadily and holds its colour; rubberwood dries fast and evenly. Both are metered the same way.

Between coats, not just before them

Each finish coat gets a scuff and a tack cloth before the next; the final coat is compared against a sealed reference panel, not against the piece next to it.

Domestic seating is tested under EN 12520 — seat and back fatigue, a leg forward load and a stability check. Light contract use moves to EN 16139 Level 1, which cycles the frame considerably harder.

The surface you will actually live with

Buyers ask about gloss and colour; the number that matters in service is how the finish stands up to cleaning agents, which is a packing-hall question as much as a spray-booth one.

Dining chair stock is the fastest moving inventory in the yard, which is good for turnover and bad for storage discipline: blanks left out through a Foshan wet season take water back within days. Covered store, metered at both ends.

The returns are front leg joints loosening, seats splitting at the end grain where the finish did not cover it, and rocking from a frame machined out of tolerance. All three are visible in the first month, not the fifth year.

Questions

What sheen levels can I order?

Matt, satin and semi-gloss on solid wood dining chairs, all matched to a sealed panel rather than a photo.

Can you match a colour I send?

Physical samples, yes; screen colours, no. Colour is signed off on a stained panel before the batch runs.

How do you keep 300 dining chairs the same colour?

One stain batch per order, one reference panel, and the booth checks against it - not against the previous chair.

What finishes are available?

NC, PU and water-based systems; the trade-offs are on the finishing page for solid wood dining chairs.