Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Dining Armchairs

Sanding and Finishing Dining Armchairs: Three Grits to Final Coat

The sanding sequence, the raking-light inspection and the reference panel that decide how a dining armchair looks under a dining room light.

Updated 2026-11-13Longjiang, Foshan11 min read

The sanding sequence, the raking-light inspection and the reference panel that decide how a dining armchair looks under a dining room light.

These notes come off the production floor in Longjiang, Foshan. The current wholesale wooden dining armchairs range is on the main site, with a specification page for every model in it.

Three grits, two inspections, one finish

Sanding is where a dining armchair earns its surface. Three grits in sequence, an inspection under raking light between the second and third, and no finish until the bench signs off.

Arms are handled constantly and show wear first, so the top face and the front end take an extra pass and the finish is built slightly higher there. The underside of the arm is finished too — it is at eye level for anyone sitting beside it.

Why sanding is compressed when a line is late

It is the easiest stage to rush and the first one the customer sees. A stain over a poorly sanded rail shows every scratch under a dining room light, so the schedule protects this bench, not the other way round.

The arm is the heavy section: 35 to 45 mm where it meets the back post, tapering forward. Back posts run 35 to 40 mm because the arm loads them, and the seat rails 22 to 25 mm. Arms are cut from a blank thicker than anything a side chair uses.

StagePurposeCheck
Grit 1Flatten and shapeMachine marks gone
Grit 2Uniform scratchRaking-light inspection
Grit 3Finish preparationBench sign-off
Stain / sealerColour vs reference panelUnder D65 light
Top coatsScuff + tack betweenGloss and feel

Sanding sequence

Species sand differently

Open-grain timber drinks stain and shows swirl marks; tight grain shows gloss differences. Grit sequence and sanding direction are set per species, not per shift.

Arms are nearly always ash, because a shaped arm needs a timber that holds a curve and takes a knock; rubberwood marks too readily for a surface people grab. Most of the charge in this category is ash for that reason.

Between coats, not just before them

Each finish coat gets a scuff and a tack cloth before the next; the final coat is compared against a sealed reference panel, not against the piece next to it.

An armchair is tested for a downward and a sideways load on the arm itself, not only for seat and back fatigue. That arm load test is what separates a hospitality-grade armchair from a domestic one.

The surface you will actually live with

Buyers ask about gloss and colour; the number that matters in service is how the finish stands up to cleaning agents, which is a packing-hall question as much as a spray-booth one.

Thick arm stock holds its moisture longer than the rails do, so the two are never stored together expecting the same behaviour. Arms are machined from stock held in the conditioned store at least a week after the kiln.

Arm to post joints opening, arm pads worn through at the front where hands land, and frames that rock because the arm stiffened the back and the legs were not machined to suit. A heavier frame is not automatically a better one.

Questions

What sheen levels can I order?

Matt, satin and semi-gloss on wooden dining armchairs, all matched to a sealed panel rather than a photo.

Can you match a colour I send?

Physical samples, yes; screen colours, no. Colour is signed off on a stained panel before the batch runs.

How do you keep 300 dining armchairs the same colour?

One stain batch per order, one reference panel, and the booth checks against it - not against the previous chair.

What finishes are available?

NC, PU and water-based systems; the trade-offs are on the finishing page for wooden dining armchairs.