The sample route for a restaurant chair - feasibility, first build, one revision round, and the sealed golden sample production is judged against.
What a sample is for
A restaurant chair sample is not a scaled-down order; it is the agreement the whole order is checked against. Every dimension, finish and packing detail that appears on the golden sample becomes a checkpoint on the production line, which is why we treat sample work as a separate operation with its own bench and its own clock.
Restaurant seating is contract-grade, thick-sectioned and the largest single load on our kilns. Getting the schedule wrong here is expensive in a way it is not in a domestic category: the failure happens in a room full of customers.
From enquiry to first sample
Buyer sends the model code or a drawing, the workshop pulls the timber and cuts one frame the same way production will - same jigs, same glue, same sanding sequence. A new restaurant chair sample takes 7 to 15 days depending on whether the tooling already exists.
Contract frames are machined heavier: legs at 45 to 55 mm, rails at 25 to 30 mm, and a stretcher mortised in on the models that get dragged rather than lifted. That stretcher joint decides whether the chair survives a year of being pulled across a floor.
| Stage | What happens | Time / output |
|---|---|---|
| 1. Enquiry | Code, drawing or photo | Feasibility answer in 24 h |
| 2. First sample | Same jigs as production | 7-15 days |
| 3. Revision | One consolidated round | 3-7 days |
| 4. Golden sample | Signed and sealed | Two pieces: buyer + retained |
| 5. Production | Checked against retained | Every carton |
Sample route
The revision round
Revisions are cheapest before the sample leaves the factory. Height, seat depth, arm profile, foam firmness and stain colour can all be changed in one round; changing them after mass production starts means re-cutting the fixtures.
A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.
Corner blocks glued and screwed, stretchers on the heavier models, and a seat rail section big enough to take a repeated racking load. The test regime cycles the frame far harder than a domestic standard does.
Golden sample and retained sample
Once approved, two samples are sealed: one travels to the buyer, one stays in the inspection area. Every carton of restaurant chairs shipped against that order is judged against the retained piece, not against memory.
EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.
Samples from the current range
The catalogue lists 486 models in this category: 85% on a solid or wood frame and 15% with an upholstered or soft cover.
Ready-made references you can order straight away: XY-24018 (Solid wood, MOQ 6 pcs), A00141 (Wood, MOQ 6 pcs), A005 (Solid wood/Rope weaving, MOQ 6 pcs).
Reference
Questions
Do you charge for samples?
Sample cost and courier are quoted separately; the amount is credited against the mass production order once it is confirmed.
How many revisions can I make?
One consolidated round is normal. Each extra round adds roughly a week because the fixture changes have to be re-proven.
Is the sample made on the production line?
Yes - same jigs, same glue, same sanding. A sample made on a special bench tells you nothing about the 600 pieces that follow.
What is a golden sample?
The signed reference both sides agree to judge the order by. We keep one, you keep one.