The sample route for a dining armchair - feasibility, first build, one revision round, and the sealed golden sample production is judged against.
What a sample is for
A dining armchair sample is not a scaled-down order; it is the agreement the whole order is checked against. Every dimension, finish and packing detail that appears on the golden sample becomes a checkpoint on the production line, which is why we treat sample work as a separate operation with its own bench and its own clock.
Armchairs carry the thickest sections in the dining range and the most awkward shape. A shaped arm has to hold a curve and meet the back post at an angle, and both fail if the timber moves after it has been machined.
From enquiry to first sample
Buyer sends the model code or a drawing, the workshop pulls the timber and cuts one frame the same way production will - same jigs, same glue, same sanding sequence. A new dining armchair sample takes 7 to 15 days depending on whether the tooling already exists.
The arm is the expensive machining job in this category. It is a shaped, tapered component that has to meet the back post at a fixed angle, and that tenon is cut on the tenoner rather than by hand — a hand-cut arm joint is the failure we get called about.
| Stage | What happens | Time / output |
|---|---|---|
| 1. Enquiry | Code, drawing or photo | Feasibility answer in 24 h |
| 2. First sample | Same jigs as production | 7-15 days |
| 3. Revision | One consolidated round | 3-7 days |
| 4. Golden sample | Signed and sealed | Two pieces: buyer + retained |
| 5. Production | Checked against retained | Every carton |
Sample route
The revision round
Revisions are cheapest before the sample leaves the factory. Height, seat depth, arm profile, foam firmness and stain colour can all be changed in one round; changing them after mass production starts means re-cutting the fixtures.
An armchair is a dining chair with a lever attached. The arm is a cantilever: every time someone pushes themselves up, the load goes through the arm into the back post and out into the rear leg. That is the joint we reinforce, and it is why an armchair is heavier than the side chair it matches.
Arms are tenoned into the back post and through-bolted where the section allows. The arm to post joint failing is the single most common armchair return in the industry, and it is a specification problem, not a manufacturing one.
Golden sample and retained sample
Once approved, two samples are sealed: one travels to the buyer, one stays in the inspection area. Every carton of dining armchairs shipped against that order is judged against the retained piece, not against memory.
An armchair is tested for a downward and a sideways load on the arm itself, not only for seat and back fatigue. That arm load test is what separates a hospitality-grade armchair from a domestic one.
Samples from the current range
The catalogue lists 253 models in this category: 87% on a solid or wood frame and 13% with an upholstered or soft cover.
Ready-made references you can order straight away: XY-24018 (Solid wood, MOQ 6 pcs), A0010 (100% Wood, MOQ 4 pcs), A005 (Ash wood, MOQ 6 pcs).
Reference
Questions
Do you charge for samples?
Sample cost and courier are quoted separately; the amount is credited against the mass production order once it is confirmed.
How many revisions can I make?
One consolidated round is normal. Each extra round adds roughly a week because the fixture changes have to be re-proven.
Is the sample made on the production line?
Yes - same jigs, same glue, same sanding. A sample made on a special bench tells you nothing about the 600 pieces that follow.
What is a golden sample?
The signed reference both sides agree to judge the order by. We keep one, you keep one.