Load ratings, humidity, repairability - the honest trade-offs between metal and wood frames on restaurant chairs.
The frame mix in this category
The catalogue lists 486 models in this category: 85% on a solid or wood frame and 15% with an upholstered or soft cover.
Frames buyers see most often: Solid wood (157), 100% Solid Wood (120), 100% Wood (65).
What metal frames buy you
Steel gives thin profiles and high load ratings, and it does not move with humidity. The trade is the process: cutting, welding, grinding and plating are a different line with different checkpoints.
A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.
Contract frames are machined heavier: legs at 45 to 55 mm, rails at 25 to 30 mm, and a stretcher mortised in on the models that get dragged rather than lifted. That stretcher joint decides whether the chair survives a year of being pulled across a floor.
| Aspect | Metal | Wood |
|---|---|---|
| Profile | Slim, high load | Warmer, repairable |
| Movement | None with humidity | Managed by design |
| Process | Weld, grind, plate | Cut, joint, finish |
| Failure mode | Weld fatigue | Moisture / joint |
| Best fit | Stacking, nightly turnover | Long-life interiors |
Metal vs wood frames
What wood frames buy you
Repairability, warmth and a joint you can re-glue in year five. Wood moves with the season, so the joinery is designed for movement rather than against it.
Corner blocks glued and screwed, stretchers on the heavier models, and a seat rail section big enough to take a repeated racking load. The test regime cycles the frame far harder than a domestic standard does.
Where each wins in service
Metal suits venues that stack, scrub and re-configure nightly. Wood suits rooms where the restaurant chair is furniture first and equipment second.
Restaurants, cafés, bistros and hotel dining rooms — the largest category we build, 490 models. Stacking four to six high is common because rooms get re-set, and a stackable frame is a different engineering job from a knock-down one.
Frames in the current range
Representative restaurant chairs models with their frames and MOQs: SM-01 (Solid wood, MOQ 4 pcs), A00105 (100% Wood, MOQ 6 pcs), A005 (solid wood, MOQ 6 pcs).
Reference
Questions
Can I get the same model in both frames?
Sometimes - several restaurant chairs designs exist in both; the specification page names the frame per model.
Which frame is stronger?
Rated loads are met by both; the difference is how they fail and how they are repaired, not a simple winner.
Do metal frames rust?
Plating and coating are specified against the destination climate; coastal projects get a different call-out.
Is one cheaper?
Depends on the model; quotations carry the frame mix, and the mix decides.