Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Solid Wood Dining Chairs

Metal and Wood Frames on Dining Chairs: Where Each Wins

Load ratings, humidity, repairability - the honest trade-offs between metal and wood frames on dining chairs.

Updated 2026-11-09Longjiang, Foshan11 min read

Load ratings, humidity, repairability - the honest trade-offs between metal and wood frames on dining chairs.

These notes come off the production floor in Longjiang, Foshan. The current solid wood dining chairs supplier range is on the main site, with a specification page for every model in it.

The frame mix in this category

The catalogue lists 269 models in this category: 82% on a solid or wood frame and 18% with an upholstered or soft cover.

Frames buyers see most often: Solid wood (79), 100% Solid Wood (77), 100% Wood (39).

What metal frames buy you

Steel gives thin profiles and high load ratings, and it does not move with humidity. The trade is the process: cutting, welding, grinding and plating are a different line with different checkpoints.

A dining chair is a four-legged frame that takes almost its entire load through the two front legs when someone sits down hard or pushes back from a table. The front leg to side rail joint is the one that decides whether the chair is tight after five years. We cut it as a mortise and tenon with a corner block.

Four legs, two side rails, two end rails and a back: the tenoner sets all of them in one fixture so a repeat order matches the first run. A tenon cut 1 mm small is a joint that stays loose for the life of the chair, and it cannot be seen until the frame is loaded.

AspectMetalWood
ProfileSlim, high loadWarmer, repairable
MovementNone with humidityManaged by design
ProcessWeld, grind, plateCut, joint, finish
Failure modeWeld fatigueMoisture / joint
Best fitStacking, nightly turnoverLong-life interiors

Metal vs wood frames

What wood frames buy you

Repairability, warmth and a joint you can re-glue in year five. Wood moves with the season, so the joinery is designed for movement rather than against it.

Seat rails are tenoned into the legs and the corner block is both glued and screwed. Screws alone work for a year; a glued block carries the racking load that a dining chair lives with. Turn the chair over and you can see the difference.

Where each wins in service

Metal suits venues that stack, scrub and re-configure nightly. Wood suits rooms where the dining chair is furniture first and equipment second.

Home dining rooms, apartments and showrooms. Seat height 450 to 470 mm against a 720 to 750 mm table, seat depth 400 to 450 mm. Standard is domestic use under EN 12520, with EN 16139 Level 1 available where the chairs go into a serviced space.

Frames in the current range

Representative dining chairs models with their frames and MOQs: A004 (Ash wood, MOQ 6 pcs), A008 (100% Solid Wood, MOQ 2 pcs), XY-24018 (Solid wood, MOQ 6 pcs).

Questions

Can I get the same model in both frames?

Sometimes - several solid wood dining chairs designs exist in both; the specification page names the frame per model.

Which frame is stronger?

Rated loads are met by both; the difference is how they fail and how they are repaired, not a simple winner.

Do metal frames rust?

Plating and coating are specified against the destination climate; coastal projects get a different call-out.

Is one cheaper?

Depends on the model; quotations carry the frame mix, and the mix decides.