Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Dining Armchairs

Metal and Wood Frames on Dining Armchairs: Where Each Wins

Load ratings, humidity, repairability - the honest trade-offs between metal and wood frames on dining armchairs.

Updated 2026-11-09Longjiang, Foshan11 min read

Load ratings, humidity, repairability - the honest trade-offs between metal and wood frames on dining armchairs.

These notes come off the production floor in Longjiang, Foshan. The current wooden dining armchairs range is on the main site, with a specification page for every model in it.

The frame mix in this category

The catalogue lists 253 models in this category: 87% on a solid or wood frame and 13% with an upholstered or soft cover.

Frames buyers see most often: Solid wood (94), 100% Solid Wood (67), 100% Wood (29).

What metal frames buy you

Steel gives thin profiles and high load ratings, and it does not move with humidity. The trade is the process: cutting, welding, grinding and plating are a different line with different checkpoints.

An armchair is a dining chair with a lever attached. The arm is a cantilever: every time someone pushes themselves up, the load goes through the arm into the back post and out into the rear leg. That is the joint we reinforce, and it is why an armchair is heavier than the side chair it matches.

The arm is the expensive machining job in this category. It is a shaped, tapered component that has to meet the back post at a fixed angle, and that tenon is cut on the tenoner rather than by hand — a hand-cut arm joint is the failure we get called about.

AspectMetalWood
ProfileSlim, high loadWarmer, repairable
MovementNone with humidityManaged by design
ProcessWeld, grind, plateCut, joint, finish
Failure modeWeld fatigueMoisture / joint
Best fitStacking, nightly turnoverLong-life interiors

Metal vs wood frames

What wood frames buy you

Repairability, warmth and a joint you can re-glue in year five. Wood moves with the season, so the joinery is designed for movement rather than against it.

Arms are tenoned into the back post and through-bolted where the section allows. The arm to post joint failing is the single most common armchair return in the industry, and it is a specification problem, not a manufacturing one.

Where each wins in service

Metal suits venues that stack, scrub and re-configure nightly. Wood suits rooms where the dining armchair is furniture first and equipment second.

Head of table, banquets, clubs and hotel suites. Arm height matters as much as seat height: if the arm will not pass under the table apron, the chair cannot be pushed in and it blocks the room. Measure the apron before you order.

Frames in the current range

Representative dining armchairs models with their frames and MOQs: A0010 (100% Wood, MOQ 4 pcs), A005 (solid wood, MOQ 6 pcs), XY-24018 (Solid wood, MOQ 6 pcs).

Questions

Can I get the same model in both frames?

Sometimes - several wooden dining armchairs designs exist in both; the specification page names the frame per model.

Which frame is stronger?

Rated loads are met by both; the difference is how they fail and how they are repaired, not a simple winner.

Do metal frames rust?

Plating and coating are specified against the destination climate; coastal projects get a different call-out.

Is one cheaper?

Depends on the model; quotations carry the frame mix, and the mix decides.