Per-model jig sets, first-article checks and scheduled fixture maintenance - why restaurant chairs number 300 matches number 1.
Consistency is a fixture problem
The difference between restaurant chairs number 1 and number 300 is not the worker's mood; it is the fixture. Drill jigs, glue racks and assembly stops turn a skill into a process.
Contract frames are machined heavier: legs at 45 to 55 mm, rails at 25 to 30 mm, and a stretcher mortised in on the models that get dragged rather than lifted. That stretcher joint decides whether the chair survives a year of being pulled across a floor.
One fixture set per model
Each restaurant chair model has its own jig set, stored and tagged with the model code. When an order re-runs a year later, the same stops and bushes come off the shelf, which is why a repeat order matches the first one.
Contract sections run heavier than domestic: 45 to 55 mm legs, 25 to 30 mm rails, and a stretcher on the models that get dragged rather than lifted. The extra section is not for show — it is what survives a room being re-set several times a day.
| Discipline | How | What it buys |
|---|---|---|
| Per-model jig set | Tagged with model code | Repeat orders match |
| First article | Measured vs retained sample | Gate before the run |
| In-run gauge | 1 in 10 blanks | Drift caught early |
| Fixture inspection | Scheduled | Wear re-cut, not tolerated |
| Storage | Racked by code | Nothing improvised |
Fixture discipline
First-article check at set-up
Every fixture set-up starts with a first article measured against the retained sample. The line does not run until the first piece passes; that single rule removes most of the batch-level surprises.
Stackable models are assembled to a tighter squareness tolerance than a domestic chair, because a stack of six that does not sit true puts a permanent twist into the frames at the bottom. The jig is checked per run, not per season.
EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.
Fixtures wear, so they are checked
Bushes elongate, stops wear, glue racks accumulate. Fixture condition is inspected on a schedule, and a worn jig is re-cut - because drift on the fixture becomes drift on every piece after it.
Seats delaminating under daily wiping, stretchers loosening on models that get dragged rather than lifted, and finishes going dull where the cleaning agent is too alkaline. Ask what cleaner the operator uses.
What this means for the buyer
Re-orders match. The restaurant chair you reordered this year sits with the ones you bought last year, which is the whole point of writing the process down.
Two per carton, 0.10 to 0.15 m³, stackable or knock-down. MOQ is 6 pieces per model, and most buyers run two to four models in one container.
Reference
Questions
How do you keep a repeat order identical?
Same fixture set, same retained sample, same gauge routine - the process, not the people, carries the consistency.
Can you match restaurant chairs we bought elsewhere?
Send us one piece or the drawings; we build a fixture set and prove it on a first article before mass production.
What happens when a jig wears?
It is re-cut on schedule. Drift is caught by the in-run gauge long before a buyer sees it.
Do fixtures slow down small orders?
No - the same fixtures run a 6-piece order and a 600-piece order, which is why small restaurant chairs orders ship on the same quality curve.