Per-model jig sets, first-article checks and scheduled fixture maintenance - why dining chairs number 300 matches number 1.
Consistency is a fixture problem
The difference between dining chairs number 1 and number 300 is not the worker's mood; it is the fixture. Drill jigs, glue racks and assembly stops turn a skill into a process.
Four legs, two side rails, two end rails and a back: the tenoner sets all of them in one fixture so a repeat order matches the first run. A tenon cut 1 mm small is a joint that stays loose for the life of the chair, and it cannot be seen until the frame is loaded.
One fixture set per model
Each dining chair model has its own jig set, stored and tagged with the model code. When an order re-runs a year later, the same stops and bushes come off the shelf, which is why a repeat order matches the first one.
Legs are cut from 42 to 50 mm square, seat rails from 20 to 25 mm, back posts 30 to 35 mm where the model carries a shaped back. The thin end — a 20 mm rail — is where drying matters most, because a thin section releases moisture fast and moves first.
| Discipline | How | What it buys |
|---|---|---|
| Per-model jig set | Tagged with model code | Repeat orders match |
| First article | Measured vs retained sample | Gate before the run |
| In-run gauge | 1 in 10 blanks | Drift caught early |
| Fixture inspection | Scheduled | Wear re-cut, not tolerated |
| Storage | Racked by code | Nothing improvised |
Fixture discipline
First-article check at set-up
Every fixture set-up starts with a first article measured against the retained sample. The line does not run until the first piece passes; that single rule removes most of the batch-level surprises.
Frames go together on a jig that holds the seat square while the glue cures. Clamp time is fixed to the adhesive specification, and the corner blocks are both glued and screwed rather than one or the other.
Domestic seating is tested under EN 12520 — seat and back fatigue, a leg forward load and a stability check. Light contract use moves to EN 16139 Level 1, which cycles the frame considerably harder.
Fixtures wear, so they are checked
Bushes elongate, stops wear, glue racks accumulate. Fixture condition is inspected on a schedule, and a worn jig is re-cut - because drift on the fixture becomes drift on every piece after it.
The returns are front leg joints loosening, seats splitting at the end grain where the finish did not cover it, and rocking from a frame machined out of tolerance. All three are visible in the first month, not the fifth year.
What this means for the buyer
Re-orders match. The dining chair you reordered this year sits with the ones you bought last year, which is the whole point of writing the process down.
Two per carton, 0.09 to 0.13 m³ a carton, most models knock-down so the seat and back come off the frame. MOQ is 6 pieces per model and mixed colours are allowed.
Reference
Questions
How do you keep a repeat order identical?
Same fixture set, same retained sample, same gauge routine - the process, not the people, carries the consistency.
Can you match dining chairs we bought elsewhere?
Send us one piece or the drawings; we build a fixture set and prove it on a first article before mass production.
What happens when a jig wears?
It is re-cut on schedule. Drift is caught by the in-run gauge long before a buyer sees it.
Do fixtures slow down small orders?
No - the same fixtures run a 6-piece order and a 600-piece order, which is why small solid wood dining chairs orders ship on the same quality curve.