Per-model jig sets, first-article checks and scheduled fixture maintenance - why bar stools number 300 matches number 1.
Consistency is a fixture problem
The difference between bar stools number 1 and number 300 is not the worker's mood; it is the fixture. Drill jigs, glue racks and assembly stops turn a skill into a process.
The column is turned or machined from a single blank wherever the model allows, because a jointed column on a high stool is a wobble waiting to happen. On swivel models the mount plate is machined to fit the tube rather than welded to a rough cut.
One fixture set per model
Each bar stool model has its own jig set, stored and tagged with the model code. When an order re-runs a year later, the same stops and bushes come off the shelf, which is why a repeat order matches the first one.
The column and the footring are the thick sections here: a 45 to 60 mm column blank, a ring formed from 25 to 30 mm stock, seat blanks at 25 to 30 mm. On the swivel models the column is bought in as tube and machined to fit the mount.
| Discipline | How | What it buys |
|---|---|---|
| Per-model jig set | Tagged with model code | Repeat orders match |
| First article | Measured vs retained sample | Gate before the run |
| In-run gauge | 1 in 10 blanks | Drift caught early |
| Fixture inspection | Scheduled | Wear re-cut, not tolerated |
| Storage | Racked by code | Nothing improvised |
Fixture discipline
First-article check at set-up
Every fixture set-up starts with a first article measured against the retained sample. The line does not run until the first piece passes; that single rule removes most of the batch-level surprises.
Assembly runs vertically: seat mount first, then the footring, then the seat. Clamping a stool square is harder than clamping a chair because the column gives you nothing to reference against — the jig does the work.
Beyond the frame test a stool gets a stability check at height and a footring load test: push the ring sideways with the stool loaded and it must not deform. Swivel models are cycled, not just sat on.
Fixtures wear, so they are checked
Bushes elongate, stops wear, glue racks accumulate. Fixture condition is inspected on a schedule, and a worn jig is re-cut - because drift on the fixture becomes drift on every piece after it.
The three returns we see: footring welds cracking after a season, swivel mechanisms that lose their gas, and seat pads compressed flat at the front edge. All three are specifiable — a closed-section ring, a contract-rated lift, and a 35 kg/m³ foam.
What this means for the buyer
Re-orders match. The bar stool you reordered this year sits with the ones you bought last year, which is the whole point of writing the process down.
Stools pack small — 0.08 to 0.12 m³ for two — so the freight per piece is the best in the catalogue and a 40HC holds a lot of them. MOQ is 6 pieces per model.
Reference
Questions
How do you keep a repeat order identical?
Same fixture set, same retained sample, same gauge routine - the process, not the people, carries the consistency.
Can you match bar stools we bought elsewhere?
Send us one piece or the drawings; we build a fixture set and prove it on a first article before mass production.
What happens when a jig wears?
It is re-cut on schedule. Drift is caught by the in-run gauge long before a buyer sees it.
Do fixtures slow down small orders?
No - the same fixtures run a 6-piece order and a 600-piece order, which is why small wooden bar stools orders ship on the same quality curve.