Inserts, levelers and coated call-outs - the hardware specification that keeps a restaurant chair serviceable for years.
Hardware is specified, not grabbed
Every screw, insert and bracket on a restaurant chair has a written call-out - thread, length, coating. The bin shelf is organised by specification because a half-millimetre of screw length is the difference between a tight joint and a stripped insert.
Stackable models are assembled to a tighter squareness tolerance than a domestic chair, because a stack of six that does not sit true puts a permanent twist into the frames at the bottom. The jig is checked per run, not per season.
Inserts where the buyer needs service
Seat decks, arm pads and leveler feet land on threaded inserts, not bare wood. The insert housing is drilled to gauge and glued, so the thread survives repeated assembly.
Corner blocks glued and screwed, stretchers on the heavier models, and a seat rail section big enough to take a repeated racking load. The test regime cycles the frame far harder than a domestic standard does.
A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.
| Item | Specification | Where it matters |
|---|---|---|
| Inserts | Threaded, glued housing | Serviceable joints |
| Screws | Length by spec | No stripped threads |
| Levelers | Nylon or steel | Floor type at the venue |
| Brackets | Coated per climate | Destination humidity |
| Spare kit | In every carton | Packing list verified |
Hardware call-outs
Levelers and the floor question
Restaurant floors are rarely flat. Leveler feet on restaurant chairs are specified for the venue type - nylon for tile, steel for something rougher - and adjusted before the frame leaves the bench.
Restaurants, cafés, bistros and hotel dining rooms — the largest category we build, 490 models. Stacking four to six high is common because rooms get re-set, and a stackable frame is a different engineering job from a knock-down one.
Coating decides where it can ship
Plated and coated hardware is chosen against the destination climate; coastal and humid projects get a different call-out than inland ones. It is a packing-list line item, not an afterthought.
Two per carton, 0.10 to 0.15 m³, stackable or knock-down. MOQ is 6 pieces per model, and most buyers run two to four models in one container.
Hardware in the inspection
Torque checks on inserts, fit checks on levelers, and a hardware count against the carton list at packing - the two screws missing in carton one are the claim nobody wants.
EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.
Reference
Questions
Is hardware included in the carton?
Yes, plus a small spare kit; the packing list counts hardware the same way it counts frames.
Can I get a specific hardware brand?
Yes for project orders - the call-out is written into the specification for restaurant chairs.
Do levelers come fitted?
Fitted and pre-adjusted; the buyer only trims them on site.
What hardware fails in service?
Almost none of it - failures come from missing spares or wrong-length screws after a re-assembly, both of which the spare kit covers.