Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Lounge Chairs

Hardware on Lounge Chairs: What We Specify and Why

Inserts, levelers and coated call-outs - the hardware specification that keeps a lounge chair serviceable for years.

Updated 2026-11-02Longjiang, Foshan11 min read

Inserts, levelers and coated call-outs - the hardware specification that keeps a lounge chair serviceable for years.

These notes come off the production floor in Longjiang, Foshan. The current wooden lounge chairs supplier range is on the main site, with a specification page for every model in it.

Hardware is specified, not grabbed

Every screw, insert and bracket on a lounge chair has a written call-out - thread, length, coating. The bin shelf is organised by specification because a half-millimetre of screw length is the difference between a tight joint and a stripped insert.

The frame is assembled, then the deck is webbed or sprung, then the foam goes on and the cover is fitted. The frame joint is only half the job; the other half is how the soft parts are held in shape, which is a different skill on the line.

Inserts where the buyer needs service

Seat decks, arm pads and leveler feet land on threaded inserts, not bare wood. The insert housing is drilled to gauge and glued, so the thread survives repeated assembly.

Frames are wood or metal under the cover, and the load path goes through the seat deck rather than the rails. Webbing or a sprung deck decides how the seat feels after a year more than the timber species does.

A lounge chair is a soft seat on a frame, not a frame with a pad. 220 of the 226 models in this category are upholstered, so the frame is a substrate: it has to hold the foam and the cover in shape under a sitter who stays put for an hour, not one who leaves in twenty minutes.

ItemSpecificationWhere it matters
InsertsThreaded, glued housingServiceable joints
ScrewsLength by specNo stripped threads
LevelersNylon or steelFloor type at the venue
BracketsCoated per climateDestination humidity
Spare kitIn every cartonPacking list verified

Hardware call-outs

Levelers and the floor question

Restaurant floors are rarely flat. Leveler feet on lounge chairs are specified for the venue type - nylon for tile, steel for something rougher - and adjusted before the frame leaves the bench.

Hotel lobbies, waiting areas, senior living, reading corners. Seat height 400 to 430 mm with the back raked further than a dining chair, because the sitter is resting rather than eating. A side table at 350 to 400 mm goes with it.

Coating decides where it can ship

Plated and coated hardware is chosen against the destination climate; coastal and humid projects get a different call-out than inland ones. It is a packing-list line item, not an afterthought.

The bulky end of the catalogue: 0.22 to 0.34 m³ per carton, one piece, fully assembled. Freight dominates the landed cost, which is why buyers consolidate them with flatter models. MOQ is 4 pieces, and 2 on some models.

Hardware in the inspection

Torque checks on inserts, fit checks on levelers, and a hardware count against the carton list at packing - the two screws missing in carton one are the claim nobody wants.

Comfort testing counts as much as strength here: foam compression set under repeated loading, cover abrasion, and a frame fatigue test at Level 1 or Level 2 depending on the traffic the lobby actually sees.

Questions

Is hardware included in the carton?

Yes, plus a small spare kit; the packing list counts hardware the same way it counts frames.

Can I get a specific hardware brand?

Yes for project orders - the call-out is written into the specification for wooden lounge chairs.

Do levelers come fitted?

Fitted and pre-adjusted; the buyer only trims them on site.

What hardware fails in service?

Almost none of it - failures come from missing spares or wrong-length screws after a re-assembly, both of which the spare kit covers.