Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Solid Wood Dining Chairs

Hardware on Dining Chairs: What We Specify and Why

Inserts, levelers and coated call-outs - the hardware specification that keeps a dining chair serviceable for years.

Updated 2026-11-02Longjiang, Foshan11 min read

Inserts, levelers and coated call-outs - the hardware specification that keeps a dining chair serviceable for years.

These notes come off the production floor in Longjiang, Foshan. The current solid wood dining chairs range is on the main site, with a specification page for every model in it.

Hardware is specified, not grabbed

Every screw, insert and bracket on a dining chair has a written call-out - thread, length, coating. The bin shelf is organised by specification because a half-millimetre of screw length is the difference between a tight joint and a stripped insert.

Frames go together on a jig that holds the seat square while the glue cures. Clamp time is fixed to the adhesive specification, and the corner blocks are both glued and screwed rather than one or the other.

Inserts where the buyer needs service

Seat decks, arm pads and leveler feet land on threaded inserts, not bare wood. The insert housing is drilled to gauge and glued, so the thread survives repeated assembly.

Seat rails are tenoned into the legs and the corner block is both glued and screwed. Screws alone work for a year; a glued block carries the racking load that a dining chair lives with. Turn the chair over and you can see the difference.

A dining chair is a four-legged frame that takes almost its entire load through the two front legs when someone sits down hard or pushes back from a table. The front leg to side rail joint is the one that decides whether the chair is tight after five years. We cut it as a mortise and tenon with a corner block.

ItemSpecificationWhere it matters
InsertsThreaded, glued housingServiceable joints
ScrewsLength by specNo stripped threads
LevelersNylon or steelFloor type at the venue
BracketsCoated per climateDestination humidity
Spare kitIn every cartonPacking list verified

Hardware call-outs

Levelers and the floor question

Restaurant floors are rarely flat. Leveler feet on dining chairs are specified for the venue type - nylon for tile, steel for something rougher - and adjusted before the frame leaves the bench.

Home dining rooms, apartments and showrooms. Seat height 450 to 470 mm against a 720 to 750 mm table, seat depth 400 to 450 mm. Standard is domestic use under EN 12520, with EN 16139 Level 1 available where the chairs go into a serviced space.

Coating decides where it can ship

Plated and coated hardware is chosen against the destination climate; coastal and humid projects get a different call-out than inland ones. It is a packing-list line item, not an afterthought.

Two per carton, 0.09 to 0.13 m³ a carton, most models knock-down so the seat and back come off the frame. MOQ is 6 pieces per model and mixed colours are allowed.

Hardware in the inspection

Torque checks on inserts, fit checks on levelers, and a hardware count against the carton list at packing - the two screws missing in carton one are the claim nobody wants.

Domestic seating is tested under EN 12520 — seat and back fatigue, a leg forward load and a stability check. Light contract use moves to EN 16139 Level 1, which cycles the frame considerably harder.

Questions

Is hardware included in the carton?

Yes, plus a small spare kit; the packing list counts hardware the same way it counts frames.

Can I get a specific hardware brand?

Yes for project orders - the call-out is written into the specification for solid wood dining chairs.

Do levelers come fitted?

Fitted and pre-adjusted; the buyer only trims them on site.

What hardware fails in service?

Almost none of it - failures come from missing spares or wrong-length screws after a re-assembly, both of which the spare kit covers.