Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Dining Armchairs

Hardware on Dining Armchairs: What We Specify and Why

Inserts, levelers and coated call-outs - the hardware specification that keeps a dining armchair serviceable for years.

Updated 2026-11-02Longjiang, Foshan11 min read

Inserts, levelers and coated call-outs - the hardware specification that keeps a dining armchair serviceable for years.

These notes come off the production floor in Longjiang, Foshan. The current wholesale wooden dining armchairs range is on the main site, with a specification page for every model in it.

Hardware is specified, not grabbed

Every screw, insert and bracket on a dining armchair has a written call-out - thread, length, coating. The bin shelf is organised by specification because a half-millimetre of screw length is the difference between a tight joint and a stripped insert.

The sequence changes for an armchair: the back assembly is built first, then the arms are fitted to it, then the frame is closed. Assembling an armchair the way you assemble a side chair leaves the arm joint last, where it cannot be clamped.

Inserts where the buyer needs service

Seat decks, arm pads and leveler feet land on threaded inserts, not bare wood. The insert housing is drilled to gauge and glued, so the thread survives repeated assembly.

Arms are tenoned into the back post and through-bolted where the section allows. The arm to post joint failing is the single most common armchair return in the industry, and it is a specification problem, not a manufacturing one.

An armchair is a dining chair with a lever attached. The arm is a cantilever: every time someone pushes themselves up, the load goes through the arm into the back post and out into the rear leg. That is the joint we reinforce, and it is why an armchair is heavier than the side chair it matches.

ItemSpecificationWhere it matters
InsertsThreaded, glued housingServiceable joints
ScrewsLength by specNo stripped threads
LevelersNylon or steelFloor type at the venue
BracketsCoated per climateDestination humidity
Spare kitIn every cartonPacking list verified

Hardware call-outs

Levelers and the floor question

Restaurant floors are rarely flat. Leveler feet on dining armchairs are specified for the venue type - nylon for tile, steel for something rougher - and adjusted before the frame leaves the bench.

Head of table, banquets, clubs and hotel suites. Arm height matters as much as seat height: if the arm will not pass under the table apron, the chair cannot be pushed in and it blocks the room. Measure the apron before you order.

Coating decides where it can ship

Plated and coated hardware is chosen against the destination climate; coastal and humid projects get a different call-out than inland ones. It is a packing-list line item, not an afterthought.

Packing runs 0.14 to 0.20 m³ for two with protective arm covers, because an arm is the easiest thing to damage in transit and the most expensive to replace. MOQ is 6 pieces per model.

Hardware in the inspection

Torque checks on inserts, fit checks on levelers, and a hardware count against the carton list at packing - the two screws missing in carton one are the claim nobody wants.

An armchair is tested for a downward and a sideways load on the arm itself, not only for seat and back fatigue. That arm load test is what separates a hospitality-grade armchair from a domestic one.

Questions

Is hardware included in the carton?

Yes, plus a small spare kit; the packing list counts hardware the same way it counts frames.

Can I get a specific hardware brand?

Yes for project orders - the call-out is written into the specification for wooden dining armchairs.

Do levelers come fitted?

Fitted and pre-adjusted; the buyer only trims them on site.

What hardware fails in service?

Almost none of it - failures come from missing spares or wrong-length screws after a re-assembly, both of which the spare kit covers.