Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Restaurant Chairs

Joints Used in Our Restaurant Chairs: Mortise, Dowel and Bolt

Which joints carry which load on a restaurant chair, and why glue, dowels and bolts are kept in separate jobs.

Updated 2026-11-01Longjiang, Foshan11 min read

Which joints carry which load on a restaurant chair, and why glue, dowels and bolts are kept in separate jobs.

These notes come off the production floor in Longjiang, Foshan. The current wholesale restaurant chairs range is on the main site, with a specification page for every model in it.

Three joint families on one restaurant chair

Mortise and tenon carries the load, dowels locate the parts, and bolts hold what the buyer will assemble or adjust later. Each does one job; problems start when a joint is asked to do all three.

Corner blocks glued and screwed, stretchers on the heavier models, and a seat rail section big enough to take a repeated racking load. The test regime cycles the frame far harder than a domestic standard does.

Where mortise and tenon goes

Leg-to-rail and any joint that takes a bending load. The shoulder hides the glue line and the long grain gives the glue somewhere to work.

A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.

JointUsed forWhy
Mortise & tenonLoad-bearing framesBending and racking loads
DowelFlat part alignmentLocation, light loads
Bolt + insertServiceable partsDisassembly and adjustment
Corner blockInside every rail junctionRacking resistance
Glue lineAll of the aboveContinuity, not gap filling

Joint selection

Where dowels and bolts go

Dowels align and locate flat parts; bolts and inserts carry parts the user will service - seat decks, arm pads, leveler feet. A bolted joint in a restaurant chair is a feature, not a shortcut, as long as the insert is properly housed.

Stackable models are assembled to a tighter squareness tolerance than a domestic chair, because a stack of six that does not sit true puts a permanent twist into the frames at the bottom. The jig is checked per run, not per season.

What a good joint looks like finished

No visible glue, no gap you can slide paper into, and no wobble with the frame off the bench. The finish is only as honest as the joint under it.

Finishes are specified for cleaning, not for depth of sheen. A restaurant seat is wiped with an alkaline agent several times a day, so the coating is chosen for chemical resistance, and the seat edges where the cloth catches are the first thing inspected.

How joints fail

In service it is almost always moisture or overloading, not the joint itself - which is why the timber numbers matter as much as the fit.

Seats delaminating under daily wiping, stretchers loosening on models that get dragged rather than lifted, and finishes going dull where the cleaning agent is too alkaline. Ask what cleaner the operator uses.

EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.

Questions

Are your joints glued or screwed?

Both, where each belongs: glued joinery carries the frame, bolts only where the buyer benefits from assembly or adjustment.

Can I get knock-down restaurant chairs?

Yes. KD versions use bolted inserts at the serviceable points and the frame is engineered so racking strength does not depend on the bolts.

What joint lasts longest?

A properly fitted mortise and tenon in dry timber. The kiln record matters as much as the fit.

How are joints tested?

Static load and racking tests per batch, judged against the retained sample.