Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Lounge Chairs

Joints Used in Our Lounge Chairs: Mortise, Dowel and Bolt

Which joints carry which load on a lounge chair, and why glue, dowels and bolts are kept in separate jobs.

Updated 2026-11-01Longjiang, Foshan11 min read

Which joints carry which load on a lounge chair, and why glue, dowels and bolts are kept in separate jobs.

These notes come off the production floor in Longjiang, Foshan. The current wooden lounge chairs supplier range is on the main site, with a specification page for every model in it.

Three joint families on one lounge chair

Mortise and tenon carries the load, dowels locate the parts, and bolts hold what the buyer will assemble or adjust later. Each does one job; problems start when a joint is asked to do all three.

Frames are wood or metal under the cover, and the load path goes through the seat deck rather than the rails. Webbing or a sprung deck decides how the seat feels after a year more than the timber species does.

Where mortise and tenon goes

Leg-to-rail and any joint that takes a bending load. The shoulder hides the glue line and the long grain gives the glue somewhere to work.

A lounge chair is a soft seat on a frame, not a frame with a pad. 220 of the 226 models in this category are upholstered, so the frame is a substrate: it has to hold the foam and the cover in shape under a sitter who stays put for an hour, not one who leaves in twenty minutes.

JointUsed forWhy
Mortise & tenonLoad-bearing framesBending and racking loads
DowelFlat part alignmentLocation, light loads
Bolt + insertServiceable partsDisassembly and adjustment
Corner blockInside every rail junctionRacking resistance
Glue lineAll of the aboveContinuity, not gap filling

Joint selection

Where dowels and bolts go

Dowels align and locate flat parts; bolts and inserts carry parts the user will service - seat decks, arm pads, leveler feet. A bolted joint in a lounge chair is a feature, not a shortcut, as long as the insert is properly housed.

The frame is assembled, then the deck is webbed or sprung, then the foam goes on and the cover is fitted. The frame joint is only half the job; the other half is how the soft parts are held in shape, which is a different skill on the line.

What a good joint looks like finished

No visible glue, no gap you can slide paper into, and no wobble with the frame off the bench. The finish is only as honest as the joint under it.

Almost none of the frame shows. What matters is that nothing rough touches the cover from inside: a splinter on a rail wears through fabric from the back within months, which is why upholstered frames are sanded and sealed even where no one will look.

How joints fail

In service it is almost always moisture or overloading, not the joint itself - which is why the timber numbers matter as much as the fit.

Seats that bottom out, covers that pill at the front edge, and frames that creak because the deck was stapled rather than webbed. Comfort complaints are almost always foam density, not frame strength.

Comfort testing counts as much as strength here: foam compression set under repeated loading, cover abrasion, and a frame fatigue test at Level 1 or Level 2 depending on the traffic the lobby actually sees.

Questions

Are your joints glued or screwed?

Both, where each belongs: glued joinery carries the frame, bolts only where the buyer benefits from assembly or adjustment.

Can I get knock-down lounge chairs?

Yes. KD versions use bolted inserts at the serviceable points and the frame is engineered so racking strength does not depend on the bolts.

What joint lasts longest?

A properly fitted mortise and tenon in dry timber. The kiln record matters as much as the fit.

How are joints tested?

Static load and racking tests per batch, judged against the retained sample.