Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Solid Wood Dining Chairs

Joints Used in Our Dining Chairs: Mortise, Dowel and Bolt

Which joints carry which load on a dining chair, and why glue, dowels and bolts are kept in separate jobs.

Updated 2026-11-01Longjiang, Foshan11 min read

Which joints carry which load on a dining chair, and why glue, dowels and bolts are kept in separate jobs.

These notes come off the production floor in Longjiang, Foshan. The current wholesale solid wood dining chairs range is on the main site, with a specification page for every model in it.

Three joint families on one dining chair

Mortise and tenon carries the load, dowels locate the parts, and bolts hold what the buyer will assemble or adjust later. Each does one job; problems start when a joint is asked to do all three.

Seat rails are tenoned into the legs and the corner block is both glued and screwed. Screws alone work for a year; a glued block carries the racking load that a dining chair lives with. Turn the chair over and you can see the difference.

Where mortise and tenon goes

Leg-to-rail and any joint that takes a bending load. The shoulder hides the glue line and the long grain gives the glue somewhere to work.

A dining chair is a four-legged frame that takes almost its entire load through the two front legs when someone sits down hard or pushes back from a table. The front leg to side rail joint is the one that decides whether the chair is tight after five years. We cut it as a mortise and tenon with a corner block.

JointUsed forWhy
Mortise & tenonLoad-bearing framesBending and racking loads
DowelFlat part alignmentLocation, light loads
Bolt + insertServiceable partsDisassembly and adjustment
Corner blockInside every rail junctionRacking resistance
Glue lineAll of the aboveContinuity, not gap filling

Joint selection

Where dowels and bolts go

Dowels align and locate flat parts; bolts and inserts carry parts the user will service - seat decks, arm pads, leveler feet. A bolted joint in a dining chair is a feature, not a shortcut, as long as the insert is properly housed.

Frames go together on a jig that holds the seat square while the glue cures. Clamp time is fixed to the adhesive specification, and the corner blocks are both glued and screwed rather than one or the other.

What a good joint looks like finished

No visible glue, no gap you can slide paper into, and no wobble with the frame off the bench. The finish is only as honest as the joint under it.

The seat is the surface people touch and see. A solid wood seat is sanded to a finer grit than the frame and the end grain is sealed, because a seat splits from the end outwards. Frames get the standard three-grit sequence.

How joints fail

In service it is almost always moisture or overloading, not the joint itself - which is why the timber numbers matter as much as the fit.

The returns are front leg joints loosening, seats splitting at the end grain where the finish did not cover it, and rocking from a frame machined out of tolerance. All three are visible in the first month, not the fifth year.

Domestic seating is tested under EN 12520 — seat and back fatigue, a leg forward load and a stability check. Light contract use moves to EN 16139 Level 1, which cycles the frame considerably harder.

Questions

Are your joints glued or screwed?

Both, where each belongs: glued joinery carries the frame, bolts only where the buyer benefits from assembly or adjustment.

Can I get knock-down dining chairs?

Yes. KD versions use bolted inserts at the serviceable points and the frame is engineered so racking strength does not depend on the bolts.

What joint lasts longest?

A properly fitted mortise and tenon in dry timber. The kiln record matters as much as the fit.

How are joints tested?

Static load and racking tests per batch, judged against the retained sample.