Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Dining Armchairs

Joints Used in Our Dining Armchairs: Mortise, Dowel and Bolt

Which joints carry which load on a dining armchair, and why glue, dowels and bolts are kept in separate jobs.

Updated 2026-11-01Longjiang, Foshan11 min read

Which joints carry which load on a dining armchair, and why glue, dowels and bolts are kept in separate jobs.

These notes come off the production floor in Longjiang, Foshan. The current wholesale wooden dining armchairs range is on the main site, with a specification page for every model in it.

Three joint families on one dining armchair

Mortise and tenon carries the load, dowels locate the parts, and bolts hold what the buyer will assemble or adjust later. Each does one job; problems start when a joint is asked to do all three.

Arms are tenoned into the back post and through-bolted where the section allows. The arm to post joint failing is the single most common armchair return in the industry, and it is a specification problem, not a manufacturing one.

Where mortise and tenon goes

Leg-to-rail and any joint that takes a bending load. The shoulder hides the glue line and the long grain gives the glue somewhere to work.

An armchair is a dining chair with a lever attached. The arm is a cantilever: every time someone pushes themselves up, the load goes through the arm into the back post and out into the rear leg. That is the joint we reinforce, and it is why an armchair is heavier than the side chair it matches.

JointUsed forWhy
Mortise & tenonLoad-bearing framesBending and racking loads
DowelFlat part alignmentLocation, light loads
Bolt + insertServiceable partsDisassembly and adjustment
Corner blockInside every rail junctionRacking resistance
Glue lineAll of the aboveContinuity, not gap filling

Joint selection

Where dowels and bolts go

Dowels align and locate flat parts; bolts and inserts carry parts the user will service - seat decks, arm pads, leveler feet. A bolted joint in a dining armchair is a feature, not a shortcut, as long as the insert is properly housed.

The sequence changes for an armchair: the back assembly is built first, then the arms are fitted to it, then the frame is closed. Assembling an armchair the way you assemble a side chair leaves the arm joint last, where it cannot be clamped.

What a good joint looks like finished

No visible glue, no gap you can slide paper into, and no wobble with the frame off the bench. The finish is only as honest as the joint under it.

Arms are handled constantly and show wear first, so the top face and the front end take an extra pass and the finish is built slightly higher there. The underside of the arm is finished too — it is at eye level for anyone sitting beside it.

How joints fail

In service it is almost always moisture or overloading, not the joint itself - which is why the timber numbers matter as much as the fit.

Arm to post joints opening, arm pads worn through at the front where hands land, and frames that rock because the arm stiffened the back and the legs were not machined to suit. A heavier frame is not automatically a better one.

An armchair is tested for a downward and a sideways load on the arm itself, not only for seat and back fatigue. That arm load test is what separates a hospitality-grade armchair from a domestic one.

Questions

Are your joints glued or screwed?

Both, where each belongs: glued joinery carries the frame, bolts only where the buyer benefits from assembly or adjustment.

Can I get knock-down dining armchairs?

Yes. KD versions use bolted inserts at the serviceable points and the frame is engineered so racking strength does not depend on the bolts.

What joint lasts longest?

A properly fitted mortise and tenon in dry timber. The kiln record matters as much as the fit.

How are joints tested?

Static load and racking tests per batch, judged against the retained sample.