Foam density, the seat deck under it, and the nested cutting that turns cloth into covers on dining chairs.
Foam is chosen by density, never by feel alone
Seat foam on a dining chair is specified by density and firmness, written into the model specification. Two foams can feel identical in the showroom and behave completely differently after a year of service.
Roughly two thirds of this category is a solid wood frame with a wood seat; the rest carries a padded seat or a woven seat. Covers on the padded models are cut to a nested marker so a repeat order matches the original run.
The seat deck underneath decides the feel
Foam sits on a deck - elastic webbing, springs or a formed plywood panel. The deck sets the base firmness; the foam tunes it. Changing foam without looking at the deck is how soft seats end up bottoming out.
A dining chair is a four-legged frame that takes almost its entire load through the two front legs when someone sits down hard or pushes back from a table. The front leg to side rail joint is the one that decides whether the chair is tight after five years. We cut it as a mortise and tenon with a corner block.
| Layer | What it is | What it decides |
|---|---|---|
| Deck | Webbing / springs / ply | Base firmness |
| Foam | Density-specified | Comfort tuning |
| Cover | Nested cutting, sewn | Waste + alignment |
| Fitting | Fixed sequence | One in ten bench check |
| Front edge | Reinforced | First place wear shows |
Seat build
Covers are cut from nested markers
Upholstery covers are nested on the cloth to control waste, cut, sewn and fitted over the foam on a fixed sequence. Seam alignment and foam density are checked on the bench, one in ten.
Roughly two thirds of this category is a solid wood frame with a wood seat; the rest carries a padded seat or a woven seat. Covers on the padded models are cut to a nested marker so a repeat order matches the original run.
Domestic seating is tested under EN 12520 — seat and back fatigue, a leg forward load and a stability check. Light contract use moves to EN 16139 Level 1, which cycles the frame considerably harder.
Comfort is a scene question
A café dining chair lives 12 hours a day and needs a firmer seat; a home dining dining chair is judged in the first hour. Same foam chemistry, different specification.
Home dining rooms, apartments and showrooms. Seat height 450 to 470 mm against a 720 to 750 mm table, seat depth 400 to 450 mm. Standard is domestic use under EN 12520, with EN 16139 Level 1 available where the chairs go into a serviced space.
What wears out first
Almost always the front edge of the seat - cover abrasion and foam collapse together. It is the reason we hold the density line even when a cheaper foam passes the showroom test.
The returns are front leg joints loosening, seats splitting at the end grain where the finish did not cover it, and rocking from a frame machined out of tolerance. All three are visible in the first month, not the fifth year.
Upholstered models in this range
The catalogue lists 269 models in this category: 82% on a solid or wood frame and 18% with an upholstered or soft cover.
Upholstered references: XY-24018 (Solid wood, MOQ 6 pcs), A003 (100% Solid Wood, MOQ 6 pcs), A005 (Solid wood/Fabric, MOQ 2 pcs).
Reference
Questions
What foam density do you use?
Seat foam is specified per model in the solid wood dining chairs range; contract projects usually take the higher-density option and home ranges the mid one.
Can I send my own fabric?
Yes - COM orders are welcome; we test stitchability and shrinkage before cutting.
Why is my sample seat firmer than the photo suggested?
Showroom light flatters soft foam. Density numbers, not photos, are what the order is built on.
How long should the seat last?
With the specified density and a contract-grade cover, years of daily service; the front edge is the honest wear indicator.