Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Lounge Chairs

NC, PU and Water-Based Finishes on Lounge Chairs

The three finish systems, what each costs in booth time and paperwork, and how the choice is made for lounge chairs.

Updated 2026-10-30Longjiang, Foshan11 min read

The three finish systems, what each costs in booth time and paperwork, and how the choice is made for lounge chairs.

These notes come off the production floor in Longjiang, Foshan. The current wooden lounge chairs range is on the main site, with a specification page for every model in it.

Three finish systems, three trade-offs

NC is fast to spray and easy to repair; PU builds film and shrugs at cleaning chemicals; water-based systems answer the emission paperwork that projects ask for. The wooden lounge chairs specification names the system per model.

Almost none of the frame shows. What matters is that nothing rough touches the cover from inside: a splinter on a rail wears through fabric from the back within months, which is why upholstered frames are sanded and sealed even where no one will look.

The booth is part of the finish

Filtered airflow, controlled humidity and clean guns - a finish system is only as good as the room it is applied in, and the room is checked the way the coats are.

The frame is a substrate for upholstery, so sections run lighter than a dining chair: 30 to 40 mm on the load-bearing rails, with a shaped ply or a webbed deck carrying the seat. Timber here is dried for stability rather than for appearance — most of it is never seen.

SystemStrengthTypical use
NCFast, repairableHome ranges, quick turns
PUHard filmContract service
Water-basedLow emissionProject paperwork
Stain + sealerColour layerPanel-signed per order
Top coatScuff between coatsBooth-controlled

Finish systems

Grain raising and species

Water-based finishes raise grain on open-pore timber and need an extra sanding pass; NC and PU behave differently. Species and system are chosen together.

The timber here is mostly hidden, so the programme runs ash and rubberwood on cost and stability rather than on figure. In this category the species conversation is about the cover, not the frame.

Durability is tested, not claimed

Finished lounge chairs go through cleaning-agent resistance and wear checks against the retained panel, because the venue will test them anyway.

Comfort testing counts as much as strength here: foam compression set under repeated loading, cover abrasion, and a frame fatigue test at Level 1 or Level 2 depending on the traffic the lobby actually sees.

Documentation for export

VOC and safety paperwork travels with the order where the destination requires it - another reason the finish system is decided before the sample, not after.

The bulky end of the catalogue: 0.22 to 0.34 m³ per carton, one piece, fully assembled. Freight dominates the landed cost, which is why buyers consolidate them with flatter models. MOQ is 4 pieces, and 2 on some models.

Questions

Which finish should I specify?

Contract lounge chairs lean PU for chemical resistance; quick-turn home ranges run NC; projects with paperwork lean water-based.

Do water-based finishes look worse?

On open grain they need an extra sanding pass; done right, the difference is the paperwork, not the look.

Can finishes be repaired on site?

NC repairs easily with touch-up; PU repairs are more visible - worth knowing before you choose.

What documentation comes with the finish?

VOC and safety papers where the destination asks; it is a line item on the order, not an afterthought.