Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Solid Wood Dining Chairs

NC, PU and Water-Based Finishes on Dining Chairs

The three finish systems, what each costs in booth time and paperwork, and how the choice is made for dining chairs.

Updated 2026-10-30Longjiang, Foshan11 min read

The three finish systems, what each costs in booth time and paperwork, and how the choice is made for dining chairs.

These notes come off the production floor in Longjiang, Foshan. The current solid wood dining chairs supplier range is on the main site, with a specification page for every model in it.

Three finish systems, three trade-offs

NC is fast to spray and easy to repair; PU builds film and shrugs at cleaning chemicals; water-based systems answer the emission paperwork that projects ask for. The solid wood dining chairs specification names the system per model.

The seat is the surface people touch and see. A solid wood seat is sanded to a finer grit than the frame and the end grain is sealed, because a seat splits from the end outwards. Frames get the standard three-grit sequence.

The booth is part of the finish

Filtered airflow, controlled humidity and clean guns - a finish system is only as good as the room it is applied in, and the room is checked the way the coats are.

Legs are cut from 42 to 50 mm square, seat rails from 20 to 25 mm, back posts 30 to 35 mm where the model carries a shaped back. The thin end — a 20 mm rail — is where drying matters most, because a thin section releases moisture fast and moves first.

SystemStrengthTypical use
NCFast, repairableHome ranges, quick turns
PUHard filmContract service
Water-basedLow emissionProject paperwork
Stain + sealerColour layerPanel-signed per order
Top coatScuff between coatsBooth-controlled

Finish systems

Grain raising and species

Water-based finishes raise grain on open-pore timber and need an extra sanding pass; NC and PU behave differently. Species and system are chosen together.

Around 70% of what we run is ash and roughly 30% rubberwood, and both appear in this category's charge book. Ash dries steadily and holds its colour; rubberwood dries fast and evenly. Both are metered the same way.

Durability is tested, not claimed

Finished dining chairs go through cleaning-agent resistance and wear checks against the retained panel, because the venue will test them anyway.

Domestic seating is tested under EN 12520 — seat and back fatigue, a leg forward load and a stability check. Light contract use moves to EN 16139 Level 1, which cycles the frame considerably harder.

Documentation for export

VOC and safety paperwork travels with the order where the destination requires it - another reason the finish system is decided before the sample, not after.

Two per carton, 0.09 to 0.13 m³ a carton, most models knock-down so the seat and back come off the frame. MOQ is 6 pieces per model and mixed colours are allowed.

Questions

Which finish should I specify?

Contract dining chairs lean PU for chemical resistance; quick-turn home ranges run NC; projects with paperwork lean water-based.

Do water-based finishes look worse?

On open grain they need an extra sanding pass; done right, the difference is the paperwork, not the look.

Can finishes be repaired on site?

NC repairs easily with touch-up; PU repairs are more visible - worth knowing before you choose.

What documentation comes with the finish?

VOC and safety papers where the destination asks; it is a line item on the order, not an afterthought.