The three finish systems, what each costs in booth time and paperwork, and how the choice is made for dining armchairs.
Three finish systems, three trade-offs
NC is fast to spray and easy to repair; PU builds film and shrugs at cleaning chemicals; water-based systems answer the emission paperwork that projects ask for. The wooden dining armchairs specification names the system per model.
Arms are handled constantly and show wear first, so the top face and the front end take an extra pass and the finish is built slightly higher there. The underside of the arm is finished too — it is at eye level for anyone sitting beside it.
The booth is part of the finish
Filtered airflow, controlled humidity and clean guns - a finish system is only as good as the room it is applied in, and the room is checked the way the coats are.
The arm is the heavy section: 35 to 45 mm where it meets the back post, tapering forward. Back posts run 35 to 40 mm because the arm loads them, and the seat rails 22 to 25 mm. Arms are cut from a blank thicker than anything a side chair uses.
| System | Strength | Typical use |
|---|---|---|
| NC | Fast, repairable | Home ranges, quick turns |
| PU | Hard film | Contract service |
| Water-based | Low emission | Project paperwork |
| Stain + sealer | Colour layer | Panel-signed per order |
| Top coat | Scuff between coats | Booth-controlled |
Finish systems
Grain raising and species
Water-based finishes raise grain on open-pore timber and need an extra sanding pass; NC and PU behave differently. Species and system are chosen together.
Arms are nearly always ash, because a shaped arm needs a timber that holds a curve and takes a knock; rubberwood marks too readily for a surface people grab. Most of the charge in this category is ash for that reason.
Durability is tested, not claimed
Finished dining armchairs go through cleaning-agent resistance and wear checks against the retained panel, because the venue will test them anyway.
An armchair is tested for a downward and a sideways load on the arm itself, not only for seat and back fatigue. That arm load test is what separates a hospitality-grade armchair from a domestic one.
Documentation for export
VOC and safety paperwork travels with the order where the destination requires it - another reason the finish system is decided before the sample, not after.
Packing runs 0.14 to 0.20 m³ for two with protective arm covers, because an arm is the easiest thing to damage in transit and the most expensive to replace. MOQ is 6 pieces per model.
Reference
Questions
Which finish should I specify?
Contract dining armchairs lean PU for chemical resistance; quick-turn home ranges run NC; projects with paperwork lean water-based.
Do water-based finishes look worse?
On open grain they need an extra sanding pass; done right, the difference is the paperwork, not the look.
Can finishes be repaired on site?
NC repairs easily with touch-up; PU repairs are more visible - worth knowing before you choose.
What documentation comes with the finish?
VOC and safety papers where the destination asks; it is a line item on the order, not an afterthought.