Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Bar Stools

NC, PU and Water-Based Finishes on Bar Stools

The three finish systems, what each costs in booth time and paperwork, and how the choice is made for bar stools.

Updated 2026-10-29Longjiang, Foshan11 min read

The three finish systems, what each costs in booth time and paperwork, and how the choice is made for bar stools.

These notes come off the production floor in Longjiang, Foshan. The current wooden bar stools supplier range is on the main site, with a specification page for every model in it.

Three finish systems, three trade-offs

NC is fast to spray and easy to repair; PU builds film and shrugs at cleaning chemicals; water-based systems answer the emission paperwork that projects ask for. The wooden bar stools specification names the system per model.

A stool is seen from below as often as from above — the underside of the seat and the footring sit at eye level for anyone at the bar. Both get the same three-grit sequence as the visible faces, and the ring is finished before it is welded.

The booth is part of the finish

Filtered airflow, controlled humidity and clean guns - a finish system is only as good as the room it is applied in, and the room is checked the way the coats are.

The column and the footring are the thick sections here: a 45 to 60 mm column blank, a ring formed from 25 to 30 mm stock, seat blanks at 25 to 30 mm. On the swivel models the column is bought in as tube and machined to fit the mount.

SystemStrengthTypical use
NCFast, repairableHome ranges, quick turns
PUHard filmContract service
Water-basedLow emissionProject paperwork
Stain + sealerColour layerPanel-signed per order
Top coatScuff between coatsBooth-controlled

Finish systems

Grain raising and species

Water-based finishes raise grain on open-pore timber and need an extra sanding pass; NC and PU behave differently. Species and system are chosen together.

Most stools here run a wood seat on a wood or metal column, so the timber in the charge is seat stock — ash on roughly 70% of the programme, rubberwood on the rest. Plated metal components arrive finished and are not part of the moisture conversation at all.

Durability is tested, not claimed

Finished bar stools go through cleaning-agent resistance and wear checks against the retained panel, because the venue will test them anyway.

Beyond the frame test a stool gets a stability check at height and a footring load test: push the ring sideways with the stool loaded and it must not deform. Swivel models are cycled, not just sat on.

Documentation for export

VOC and safety paperwork travels with the order where the destination requires it - another reason the finish system is decided before the sample, not after.

Stools pack small — 0.08 to 0.12 m³ for two — so the freight per piece is the best in the catalogue and a 40HC holds a lot of them. MOQ is 6 pieces per model.

Questions

Which finish should I specify?

Contract bar stools lean PU for chemical resistance; quick-turn home ranges run NC; projects with paperwork lean water-based.

Do water-based finishes look worse?

On open grain they need an extra sanding pass; done right, the difference is the paperwork, not the look.

Can finishes be repaired on site?

NC repairs easily with touch-up; PU repairs are more visible - worth knowing before you choose.

What documentation comes with the finish?

VOC and safety papers where the destination asks; it is a line item on the order, not an afterthought.