Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Wooden Dining Armchairs

Colour Matching Dining Armchairs: Stains, Panels and Light

Sealed panels, one stain batch per order and the two-light check that keeps colour honest on dining armchairs.

Updated 2026-10-22Longjiang, Foshan11 min read

Sealed panels, one stain batch per order and the two-light check that keeps colour honest on dining armchairs.

These notes come off the production floor in Longjiang, Foshan. The current wholesale wooden dining armchairs range is on the main site, with a specification page for every model in it.

Colour is agreed on wood, not on screens

Every dining armchair order gets a physical stained panel, sealed and signed by both sides. Screen colours shift with the monitor and the room; a sealed panel does not.

Arms are handled constantly and show wear first, so the top face and the front end take an extra pass and the finish is built slightly higher there. The underside of the arm is finished too — it is at eye level for anyone sitting beside it.

One stain batch per order

Stain is mixed per order and logged. The booth matches against the panel under controlled light, so dining armchair number 400 is compared with the same reference that dining armchair number 1 was.

An armchair is tested for a downward and a sideways load on the arm itself, not only for seat and back fatigue. That arm load test is what separates a hospitality-grade armchair from a domestic one.

ControlMethodWhy
Sealed panelSigned per orderThe contract of record
Stain batchMixed and logged per orderOne batch, no drift
Light checkTwo sourcesMetamerism caught early
Species pairingColour and timber specified togetherPredictable uptake
Aftercare sheetApproved cleaning agentsColour survives service

Colour control

Species changes the same stain

The same stain formula lands differently on open grain than on tight grain, so species and colour are specified together, never separately.

Arms are nearly always ash, because a shaped arm needs a timber that holds a curve and takes a knock; rubberwood marks too readily for a surface people grab. Most of the charge in this category is ash for that reason.

Metamerism: the showroom problem

A pair that matches under shop light can split under warm restaurant light. Panels are checked under two light sources for exactly this reason - dining armchairs in a project live under mixed lighting, not under a light box.

Head of table, banquets, clubs and hotel suites. Arm height matters as much as seat height: if the arm will not pass under the table apron, the chair cannot be pushed in and it blocks the room. Measure the apron before you order.

Keeping colour honest in service

Cleaning chemicals and sunlight move colour over the years; the aftercare sheet says which agents are safe so the panel match survives the venue.

Thick arm stock holds its moisture longer than the rails do, so the two are never stored together expecting the same behaviour. Arms are machined from stock held in the conditioned store at least a week after the kiln.

Questions

Can you match Pantone or RAL?

On stained timber we match to a physical panel, not a number; send the target and we sign off a stained dining armchair panel first.

Why does my sample look different at night?

Lighting. We check panels under two sources so the match survives the venue, not just the showroom.

Do touch-up supplies ship with the order?

Yes - stain and finish touch-up for the order ships with the first carton.

How consistent is colour across 300 pieces?

One stain batch per order plus panel checks in the booth; variation stays inside what a sealed panel defines.