Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Restaurant Chairs

Restaurant Chairs for Banquet Halls: Stacking, Uniformity, Waves

Five hundred seats stored Monday, seated Saturday - the engineering and logistics behind banquet-grade restaurant chairs.

Updated 2026-10-20Longjiang, Foshan11 min read

Five hundred seats stored Monday, seated Saturday - the engineering and logistics behind banquet-grade restaurant chairs.

These notes come off the production floor in Longjiang, Foshan. The current restaurant chairs supplier range is on the main site, with a specification page for every model in it.

Banquet seating is logistics wearing furniture

A banquet hall stores 500 restaurant chairs on Monday and seats 500 guests on Saturday. Uniformity, stackability and repair-ability outrank every aesthetic question.

Restaurants, cafés, bistros and hotel dining rooms — the largest category we build, 490 models. Stacking four to six high is common because rooms get re-set, and a stackable frame is a different engineering job from a knock-down one.

Stacking is engineering

Stack loads, leg alignment and protective spacing are designed in, not discovered on site. A restaurant chair that stacks ten high needs frames that stay square after a hundred stacks.

A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.

ItemDesign pointService reality
StackingDesigned loads + spacingSquare after 100 stacks
UniformityOne fixture setNo wobble at table nine
StorageCartons for racks/trolleysPads counted as parts
WavesRetained samples keptSeason re-orders match
RepairServiceable jointsVenue team can fix

Banquet checklist

Uniformity across hundreds

Guests notice wobble at table nine. One fixture set runs the whole order and the in-run gauge keeps restaurant chair number 480 as square as number 8.

Contract frames are machined heavier: legs at 45 to 55 mm, rails at 25 to 30 mm, and a stretcher mortised in on the models that get dragged rather than lifted. That stretcher joint decides whether the chair survives a year of being pulled across a floor.

EN 16139 Level 2 is the contract grade: higher cycle counts on seat and back, a leg forward load, and a stability test that assumes the user does not sit down gently. Reports are raised per model, not per range.

Storage and transport

Cartons are sized for trolley lanes and storage racks, and the packing list counts protective pads as seriously as frames - storage damage is banquet damage.

Two per carton, 0.10 to 0.15 m³, stackable or knock-down. MOQ is 6 pieces per model, and most buyers run two to four models in one container.

Through the season

Banquet houses re-order in waves before event seasons; retained samples and kept fixtures mean wave two matches wave one.

This stock moves in volume and it is metered at packing as well as at the kiln, because a container of restaurant seating sits in a humid port before it is unloaded, and the reading at destination is the one that matters.

References banquet buyers reorder: A00152 (100% Wood, MOQ 6 pcs), A005 (Solid wood, MOQ 6 pcs), XY-24018 (Solid wood, MOQ 6 pcs).

Questions

What MOQ applies to banquet orders?

The most common order quantity in this category is 6 pcs (409 models ship at that level).

Do banquet restaurant chairs need special frames?

Stack-rated frames with reinforced junctions - a standard frame stacked nightly will not survive a season.

Can waves ship months apart?

Yes, fixtures and retained samples are retained so later waves match.

What about venue repairs?

Serviceable joints and a spare kit per carton; the venue team handles most repairs without the factory.