Guangdong Chair Factory Notes Production floor, Longjiang · Foshan

Factory Notes › Restaurant Chairs

Ash or Rubberwood for Restaurant Chairs: Choosing the Timber

Hardness, grain, movement and cost - how to choose between ash and rubberwood for a restaurant chair order.

Updated 2026-10-17Longjiang, Foshan11 min read

Hardness, grain, movement and cost - how to choose between ash and rubberwood for a restaurant chair order.

These notes come off the production floor in Longjiang, Foshan. The current wholesale restaurant chairs range is on the main site, with a specification page for every model in it.

Two timbers, two different contracts

Ash and rubberwood dominate this category, and they are not interchangeable. Ash brings hardness and an open grain that takes stain beautifully; rubberwood brings cost control and a tight, even grain.

Ash carries most of this programme and rubberwood covers the rest, both bought to a specification that assumes contract service: ash where the frame takes a daily racking load, rubberwood where the price point has to work.

Hardness and service life

Ash takes a beating - legs and rails in hard service stay honest. Rubberwood is softer under the knife and under use, which is why frame details are chunkier when it is specified.

A restaurant chair is specified for turnover, not for comfort in the abstract. It gets sat in hard, dragged across a floor and wiped down several times a day. Frames are built to EN 16139 Level 2 and the seat is designed to survive cleaning, which rules out a lot of domestic construction.

PropertyAshRubberwood
HardnessHighModerate
GrainOpen, striking under stainTight, uniform
MovementManaged by kiln + designManaged by design
CostHigherLower
Typical useStained, hard servicePainted, volume orders

Ash vs rubberwood

Stability in humid rooms

Both are kiln-dried to the same 8-12% band; their movement in service still differs, and joint details are adjusted per species rather than copied.

Contract sections are thick, and with 490 models this category is most of what goes through the kiln. Thick stock dries slowly and checks if pushed, so the charge is grouped by section and the schedule is written to the thickest blank in it.

Corner blocks glued and screwed, stretchers on the heavier models, and a seat rail section big enough to take a repeated racking load. The test regime cycles the frame far harder than a domestic standard does.

How they look after finishing

Open grain after a stain has depth; tight grain reads cleaner and more uniform. Colour panels are signed per species because the same stain is not the same colour on both.

Finishes are specified for cleaning, not for depth of sheen. A restaurant seat is wiped with an alkaline agent several times a day, so the coating is chosen for chemical resistance, and the seat edges where the cloth catches are the first thing inspected.

Choosing between them for your project

Hard service and stained looks lean ash; budget-driven volume leans rubberwood. The restaurant chairs range carries both, and the specification sheet says which is which.

Restaurants, cafés, bistros and hotel dining rooms — the largest category we build, 490 models. Stacking four to six high is common because rooms get re-set, and a stackable frame is a different engineering job from a knock-down one.

Current restaurant chairs references: A003 (100% Solid Wood, MOQ 6 pcs), A005 (Solid wood, MOQ 6 pcs), XY-24018 (Solid wood, MOQ 6 pcs).

Questions

Which timber should I pick for restaurant chairs?

Tell us the venue and the finish; hard service and stained work lean ash, budget volume leans rubberwood.

Is rubberwood a 'cheap' wood?

It is a managed plantation timber with different properties, not a worse one - the design compensates where it must.

Do both ship with moisture records?

Yes, 8-12% band, meter per batch, printed on the packing list.

Can I mix species in one order?

Yes, with per-species colour panels; the two take the same stain differently.