Hardness, grain, movement and cost - how to choose between ash and rubberwood for a lounge chair order.
Two timbers, two different contracts
Ash and rubberwood dominate this category, and they are not interchangeable. Ash brings hardness and an open grain that takes stain beautifully; rubberwood brings cost control and a tight, even grain.
The timber here is mostly hidden, so the programme runs ash and rubberwood on cost and stability rather than on figure. In this category the species conversation is about the cover, not the frame.
Hardness and service life
Ash takes a beating - legs and rails in hard service stay honest. Rubberwood is softer under the knife and under use, which is why frame details are chunkier when it is specified.
A lounge chair is a soft seat on a frame, not a frame with a pad. 220 of the 226 models in this category are upholstered, so the frame is a substrate: it has to hold the foam and the cover in shape under a sitter who stays put for an hour, not one who leaves in twenty minutes.
| Property | Ash | Rubberwood |
|---|---|---|
| Hardness | High | Moderate |
| Grain | Open, striking under stain | Tight, uniform |
| Movement | Managed by kiln + design | Managed by design |
| Cost | Higher | Lower |
| Typical use | Stained, hard service | Painted, volume orders |
Ash vs rubberwood
Stability in humid rooms
Both are kiln-dried to the same 8-12% band; their movement in service still differs, and joint details are adjusted per species rather than copied.
Upholstered frames are dried for stability rather than for looks: a rail that moves inside a cover shows as a wrinkle or a split seam instead of a crack, and it is far harder to diagnose afterwards. This stock is held to the tighter end of the band.
Frames are wood or metal under the cover, and the load path goes through the seat deck rather than the rails. Webbing or a sprung deck decides how the seat feels after a year more than the timber species does.
How they look after finishing
Open grain after a stain has depth; tight grain reads cleaner and more uniform. Colour panels are signed per species because the same stain is not the same colour on both.
Almost none of the frame shows. What matters is that nothing rough touches the cover from inside: a splinter on a rail wears through fabric from the back within months, which is why upholstered frames are sanded and sealed even where no one will look.
Choosing between them for your project
Hard service and stained looks lean ash; budget-driven volume leans rubberwood. The wooden lounge chairs range carries both, and the specification sheet says which is which.
Hotel lobbies, waiting areas, senior living, reading corners. Seat height 400 to 430 mm with the back raked further than a dining chair, because the sitter is resting rather than eating. A side table at 350 to 400 mm goes with it.
Current wooden lounge chairs references: GDC-5652 (Velvet/Fabric/Leather, MOQ 2 pcs), GDC-5652 (Velvet/Fabric/Leather, MOQ 4 pcs), GDC-5652 (Velvet/Fabric/Leather, MOQ 4 pcs).
Reference
Questions
Which timber should I pick for lounge chairs?
Tell us the venue and the finish; hard service and stained work lean ash, budget volume leans rubberwood.
Is rubberwood a 'cheap' wood?
It is a managed plantation timber with different properties, not a worse one - the design compensates where it must.
Do both ship with moisture records?
Yes, 8-12% band, meter per batch, printed on the packing list.
Can I mix species in one order?
Yes, with per-species colour panels; the two take the same stain differently.