Hardness, grain, movement and cost - how to choose between ash and rubberwood for a bar stool order.
Two timbers, two different contracts
Ash and rubberwood dominate this category, and they are not interchangeable. Ash brings hardness and an open grain that takes stain beautifully; rubberwood brings cost control and a tight, even grain.
Most stools here run a wood seat on a wood or metal column, so the timber in the charge is seat stock — ash on roughly 70% of the programme, rubberwood on the rest. Plated metal components arrive finished and are not part of the moisture conversation at all.
Hardness and service life
Ash takes a beating - legs and rails in hard service stay honest. Rubberwood is softer under the knife and under use, which is why frame details are chunkier when it is specified.
A stool carries its load differently from a chair. The seat is high, the base is narrow relative to the height, and the footring takes a sideways kick every time someone climbs on or pushes off. That is why the ring on our stools is a welded closed section joined to the column, not a ring screwed into a leg.
| Property | Ash | Rubberwood |
|---|---|---|
| Hardness | High | Moderate |
| Grain | Open, striking under stain | Tight, uniform |
| Movement | Managed by kiln + design | Managed by design |
| Cost | Higher | Lower |
| Typical use | Stained, hard service | Painted, volume orders |
Ash vs rubberwood
Stability in humid rooms
Both are kiln-dried to the same 8-12% band; their movement in service still differs, and joint details are adjusted per species rather than copied.
A stool column is a thick section and a footring is a bent one, and both come out of the same charge as thinner seat blanks. That is exactly the case where one schedule delivers two moisture contents, so the thick stock is dried separately.
The critical junction is where the column meets the seat mount and where the footring meets the column. On a swivel model the gas lift is a bought-in component and we test the assembly, not just the frame: a lift rated for office duty is not the same part as one rated for a bar that runs twelve hours a day.
How they look after finishing
Open grain after a stain has depth; tight grain reads cleaner and more uniform. Colour panels are signed per species because the same stain is not the same colour on both.
A stool is seen from below as often as from above — the underside of the seat and the footring sit at eye level for anyone at the bar. Both get the same three-grit sequence as the visible faces, and the ring is finished before it is welded.
Choosing between them for your project
Hard service and stained looks lean ash; budget-driven volume leans rubberwood. The wooden bar stools range carries both, and the specification sheet says which is which.
Height decides everything: 650 mm seat for a 900 mm bar top, 750 mm for a 1050 mm counter. Get it wrong by 50 mm and the sitter either perches or cannot reach the top. Kitchen islands in apartments are the fastest growing part of this category.
Current wooden bar stools references: A001 (100% Solid Wood, MOQ 50 pcs), A10031 (100% Solid Wood, MOQ 4 pcs), HDJCH (Leather/Velvet/Fabric, MOQ 6 pcs).
Reference
Questions
Which timber should I pick for bar stools?
Tell us the venue and the finish; hard service and stained work lean ash, budget volume leans rubberwood.
Is rubberwood a 'cheap' wood?
It is a managed plantation timber with different properties, not a worse one - the design compensates where it must.
Do both ship with moisture records?
Yes, 8-12% band, meter per batch, printed on the packing list.
Can I mix species in one order?
Yes, with per-species colour panels; the two take the same stain differently.